Ice maker hookup instructions How to Install a Water Line for a Refrigerator Ice Maker

Ice maker hookup instructions

Tapping the Cold Water Line

To hold the water line in place, use the provided adhesive clips to run the water line to the back of the freezer. Attach the Water Supply Line Step 6: Run the Water Line Step 2: We removed the drainpipes to clearly show this project. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line.

Wrap threads on the cold water valve with two or three wraps of thread-seal tape. Next, tighten down the "T" handle until it's tight and pierces the copper line.

Required Tools for this Project

Install the Icemaker Step 8: Turn the cold water supply valve on beneath the sink. Connect the ferrule and pressure nut to the hose at the refrigerator end.

Korean dating show

Slip the compression nut that came with the kit over the newly installed supply line. Drill as close to the back wall of the cabinet as possible, so you do not lose storage space inside the cabinet.

If you must use a horizontal pipe, place the hole for the valve either on the top or side of the pipe. Then slide on the compression fittings, lubricate the threads on the refrigerator fitting with pipe compound and screw on the tubing. To start, locate the cold ice maker hookup instructions source nearest to the refrigerator—perhaps under the kitchen sink, below the floor, in the wall or even in the ceiling.

Push the refrigerator against the wall. For a DIYer, if codes allow -- a needle valve is recommended.

Hookup spots in nyc

About the Author Thomas Ferraioli began writing in Figure 6 to 8 ft. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier. If not, you will need to run a line to the nearest cold water pipe, which is probably in the floor below your kitchen. Now turn on the faucet shutoff valve under the sink and check for leaks at the Adapt-a-Tee connections.

Plumb the fridge

An Adapt-a-Tee is an ideal plumbing fitting for this ice maker hookup instructions. Sign Up for More No Thanks. There are a few different types of valves that can be used. Bathroom How Tos 6 Videos.

Pua online dating routines

Before you cut the tubing to its final length, make sure you have 6 to 8 ft. Let 1 or 2 gallons of water run through the new line to remove the air. Thread the ferrule from the kit onto the new line.

Install It

Next, cut out a small section of the cold water pipe and solder in a copper tee. You may have three water supply lines beneath the sink; two lines connect directly to the faucet while the third line connects to the dishwasher. To straighten coiled tubing not the entire rollhave a partner hold the end of the tube flat on the floor, then free jamaican online dating the roll against the floor while unrolling to the length you need to go through the cabinets.

Dating site junk mail

Tighten up the mounting screws to secure the unit to the freezer wall, and then add the ice bucket under the kit. Drill a hole behind the refrigerator, and then one underneath the sink.